Electroswitch

The Control Switch Relay with SCADA Disable (CSR/SD) operates like a standard CSR, allow- ing both SCADA and manual operation. Pushing in the handle disables remote operation leav- ing only Local/Manual operation possible, allowing testing and service to be performed safe- ly. In addition, the CSR/SD also provides 2 N/O and 2 N/C contacts, push activated, for customer use as SCADA feedback of status indication. Series 24 Control Switch Relays with SCADA Disable The CSR/SD maintains all the exceptional quality and functionality of the CSR with the added benefit of a SCADA disable function. Consult factory for control circuit designs and ordering information. OPERATION • Handle pulls out 3/8” to allow remote operation of the CSR from SCADA, as well as< local/manual operation. • When the CSR handle and shaft is pushed in, the remote operation of the CSR is disabled,< and only local/manual operation remains possible. • The CSR remains in the “Normal” position, vertical at 0 degrees. < • 2 N/O and 2 N/C lateral contacts are provided and will operate via the 3/8 “ axial < movement (push/pull) of the CSR/SD handle shaft. • Target flag agreement is always true regardless of remote or local mode. < • Electrical connections (15 amp, 600 volt) are provided for the 2 N/C and N/O contacts< at the terminal block deck located at the rear of the CSR/SD. These can be used to provide customer status indication. CONTACTS POS. X 3 X 4 X 7 X 8 X 1 X 2 X 5 X 6 1 2 FROM 1 3 1 3